Awesome wing!! Just buy it!
Import Image Racing delivered! OLM Delivered! Everything is great! Just installed this wing last night and I just wanted to say how stoked I am. After watching an install video on YT (there is only two?) The Subaru owner said he would go with the carbon fiber unit if he could do it again. So I ordered that one.
I knew I could install this wing with a few tools and a few hours time.
Wing came well packed tight and padded well. In the box came the wing, hardware, and install template. No instructions. It really is NOT that hard to figure out where the hardware goes. Lay all hardware out on a table, pair it up, and then youll see what everyone goes to.
I reccomend the following tools.
Drill with sharp metal bits
1" hole saw for drilling out two areas for 10MM stud nuts to be recessed.
Blue locktite (vibration will loosen things over time)
8&10MM long sockets w/ ratchet
Metric allen key set
Flat head and Phillips Screw Driver
Sharpie marker to mark holes on trunk
metal punch ( so your drill bit doesnt skip across the trunk!)
touch up paint or primer to paint freshly drilled holes
1 hours time
I used locktite on the screws that hold the wing ends, wing bracket and wing bracket studs. You don't want this to slowly rattle loose and have to tighten it up later.
I installed my wing backwards. I put the wing supports on the trunk and tightened everything up but not too tight for flex. Then I installed the wing onto the wing supports. This is so you can install this wing…