Dialed Mounts Dock Mount Subaru WRX / STI 2008-2014 | 2000-08-14

Id give this 3.5 stars if I could honestly. They’re lucky i rounded up.

The good: Very cleanly printed or molded plastic looks much better than cheap 3d printed ones. The dock perfectly holds the cord and holds the buttons down on the side for easy removal. The magnet holds the AP extremely well even on gravel roads- not sure why every company doesnt add this to their design.

The bad: First off it doesnt connect to the air vent like the OEM piece, its far to shallow. Even if it did connect, the vents are printed/molded in the wrong direction! Not sure how you even make that mistake lol.

I have yet to find the perfect AP vent holder, but this one will at least stay in the car for now.

Installation was very straightforward and the product seems to be of good quality. However, without any NVH dampening on the access port cradle, there is some noise going over rough roads. Nothing a thin layer of felt can't solve.

so easy to install and when it’s all done it looks so sleek. i hate wires hanging everywhere and this was the best solution to that

It works well, the accessport will pop out if you hit a bounce and it rattles but fixed this with a rubber strip. Overall though nice placement and very convenient to clean up the wires.

This is an awesome mount for your Cobb AP! You can just pop your AP in to the mount and the way it’s designed it connects right up to the wire and turns on. It looks to be made by a 3D printer so it is a bit rough looking. It is super easy to install. So far I like it!

1. It does not come with instructions but you can use this video as a baseline. You will just have to remove and extra screw and wiggle the wire up. Pretty easy install https://youtu.be/NulojwomvPk

2. The quality is super rough and even when tightened down it can wobble and move around under sporty driving. The top of the AP almost touches the glass.

3. For 45 bucks you think you it would be better than this. I am keeping it but there has to be a better option. Would not recommend it.

Best looking mount for your AP. The magnet did come off but added a little superglue and its holding strong now.

First off, there are no instructions so have fun. Second, the edges are a bit rough as this is 3D printed. finally, you need to remove the vent which lets the air go under the dash, and the vent that is built-in faces the wrong way.

Makes my car look nicer with less wires

This mount is great, easy install and cleans up the access port cable. Little pricey because of shipping but I wouldn’t buy another mount!