Dialed Mounts Cobb AP Mount Subaru WRX / STI 2002-2007

I no longer have a problem with a proper mount for my 02 wrx accessport!

i like this mount and there's no other like it, that i can find. Thankfully its rather simple so the lack of instructions wasn't a deal breaker. Could use some instructions to help out. The BIGGEST issue is that it doesn't really fit. It'll mount just fine in the vent. But with the AP on it, there's no room for it to properly sit. The arm doesn't go high enough to allow the cable to plug in to the bottom of the AP nicely with room. The arm doesn't angle out far enough to keep the top of the AP from rubbing the a pillar. Its a 3d printed mount. Please read this and read the other reviews saying the same thing and redesign this with a better arm so it actually fits nicely.

Mount works perfect. Just took a few min to figure out how to put together. Very easy to figure it out but would help if printed a paper with instructions

It’s in the ballpark decent, 3 things I didn’t like... the screws are already rusty “only had it a week or so” and the know to tighten is kinda junky. The design is smart but the fit and finish is ehhh. It’s crude is texture “3D printed choppy look” and the base that suppose to hold the nuts don’t stay in the base...I lost 1 screw trying to mount it. overall it’s still better than using a suction mount or 3m taped mount.

Ok so there's no install instructions.

Too close to the a-pillar

Look rough

But other than those three things. Works as intended and is very stable when installed properly with included items no glue or anything was needed

Had to super glue it bc it wasn’t stable

Easy install and easy setup. Only issue is that the top left corner of the AP is very close to the A-pillar. But other than that, it's so nice to have this mounted where it's visible and also out of the way.

So the mount itself is a little challenging to get set right since pushing in the piece pushes the bottom plate up against the base. I folded a long piece of paper between the base and plate with a tail fed through vent to keep the pieces spaced to get dash between them. Once mounted though it definitely isn't going anywhere and works well.

Hardest part was getting the vent out, which yes, you WILL need to remove your gauge cluster to do so.

This is awesome! Very easy to install however I recommend ditching the Allen tool that is supplied and use one that is a bit longer. The vent still works as it should and is very sturdy.

I was looking for this mount in a long time! I love how clean it looks and stays in one spot I love it!

https://youtu.be/-E1ShM-fths