66.1 Hub bore (Nissan and Infiniti)

5x114.3 Bolt Pattern

15mm Spacing

ATTENTION: Before installing the wheels on the vehicle make sure the vehicle studs are not making contact on the back of the wheel. If the studs are making contact with the back of the wheel, you will need to shave down your vehicle studs. If you do not, your wheels WILL fall off.

Torque all studs to factory specs.

We recommend checking spacer to vehicle nut torque after a short drive.

Red loctite is recommended.

Made from T6-7075 aluminum. What the hell does that mean? It means it's strong. We decided to build our spacers out of the harder 7075 over the softer 6061. 7075 is used for things like planes, marine equipment and AR-15 rifles. It is in fact overkill for spacers, but if you want the best at a great price, here it is.

Grade 12.9 hardware, again, we have gone overkill here. Typical sets on the internet you will find are grade 8.8 or 10.9. On an M12 10.9 stud, torque specs are typically maxed at 140ft pounds. A 12.9 m12 stud comes in closer to 170ft lbs. Your typical car needs a torque spec of about 80-95ft lbs, so once again, we have made these overkill! Please DO NOT torque your wheels or spacers to 170ft lbs! Your car studs will fail way before these studs give out.

Hub Bore matched to your Nissan or Infiniti

We do not make "universal" hub bore spacers. This means each size is made specifically for your car. While the weight of the vehicle should never be riding on the center bore of the wheel, it adds a level of confidence to the install and stability of running wheel spacers. There is one downside, and that is that you must order the correct hub bore for your vehicle!

We sell these as pairs, so if you need 4 order a quantity of 2!