Overnight.Crew OG Design V1 Wheel Spoke Decals for AVID.1 AV06 (Set of Four)

Installation Instructions

Dry Application:​

​For best results, it is recommended for ambient temperature to be 60° F or above. Steps may need to be repeated if wheels are ceramic coated.

1. ​Take a dry cloth with alcohol or window cleaner and wipe down the spoke of the wheel you want to apply your decal to.
2. Flip the decal over rubbing it a few times on the back side to ensure you get the whole decal to stick to the application tape.
   
3. Slowly peel off the application tape and decal from the backing. Make sure all the decal stays on the application tape.
   
4. Apply sticker to the wheel spoke you just cleaned.
   
5. Now with a dry cloth or squeegee rub the decal, working from one side to the other to make sure you have it sticking good.
   
6. Now remove the application tape slowly to ensure your decal sticks to the spoke you have just applied it to.
   

If your decal starts to pull up off the wheel with the application tape, push it back down and repeat step 5.

Wet Application:​

​For best results, it is recommended for ambient temperature to be 60° F or above. Steps may need to be repeated if wheels are ceramic coated.

1. Spray surface generously with soapy water.
2. Peel the backing from the decal exposing the adhesive. Spray the back of the vinyl as you peel it back.
   
3. Place the decal on the surface ensuring no part of the decal touches a dry spot. Maneuver the decal into position.
   
4. Once in position, use a squeegee or an old credit card, start from the center and work the water bubbles out towards the edge. (Don’t allow direct contact between the squeegee or credit card with the vinyl as this will scratch it!)
5. Apply sticker to the wheel spoke you just cleaned.
   
6. Now with a dry cloth or squeegee rub the decal, working from one side to the other to make sure you have it sticking good.
   
7. Now remove the application tape slowly to ensure your decal sticks to the spoke you have just applied it to.

If your decal starts to pull up off the wheel with the application tape, push it back down and repeat step 5.