A.70101.1
OLM A1 Aggressive Carbon Fiber Full Replacement Hood Scoop
For your:
Full hood scoop replacement. You will need to remove your OEM hood scoop which will require popping clips from underneath the hood and removing a few nuts on the front side of the scoop. Comes with 3M for a secure fit along the edges. Once installed, we recommend using a silicon sealant around the scoop. This will seal it well and no water will get under the scoop.
NOTE: Always clean the back of the hood scoop and the hood area with rubbing alcohol before starting the installation. We recommend re-installing the black plastic trim under the hood once you are done. This will help direct air to the intercooler.
Looks amazing but make sure you get some double sided tape to hold it down. If you just use the bolts, their are visible gaps. After I used the double sided tape it looks great.
Looks amazing and install was super easy
Looks good and aggressive once it's on the car. The build quality is sorta ok, mine came with an imperfection in the resin/carbon to which the supplier basically said "it happens, new units will take months for a replacement" so I just stuck with it. You have to play around a little with the mesh to get it to fit flush on the hood, and I recommend 3M tape all around the edges since the only thing holding it in place are the front screws. It takes some trial and error to get right.
Thanks for subscribing!
This email has been registered!
