Perrin Reverse Lockout Lever Subaru STI 2004-2021 | PSP-INR-250BK

The install was a little difficult getting the roll pin out and then climbing underneath the car to give my shift cable some slack. But once I figured that out it was smooth sailing.

22 VB STI trans swap. Had the billetworkz first, it was too tight on the kartboy lever and would get stuck up constantly. Also, the shift boot would not stay on the retainer. The Perrin fixed both these issues and works flawlessly so far.

Enough said!

The amount of money you pay for this it is not honestly worth it.. It should had came with a reverse lockout pin made to fit it perfectly. I spent over 2h trying to hit the pin into place and it finally went all the way in. Honestly you would need to dremel a little of the oem pin from the tip of insert for it to go in easily.

It feels nicer than stock but the issue is that it gets stuck when you push it up unless you push it down manually. Trust me I put in a lot of grease to make sure it slides down properly but resorted on manually pushing it down.

Stick with Oem if you do not mind pushing the reverse lock down manually after reversing.

Overall it is a decent item. There are better options. I would not buy Perrin again after this ordeal I went through.

Nice quality, but does not fit with kartboy shifter and there was nothing stating that on here when I bought it.

Honestly worth the money. Great build quality and feels great

Feels good. Works as it should. Doesn't rattle at high speed, unlike my worn out stock one. Good product.