AVS Ventvisor In-Channel Front & Rear Window Deflectors 4pc Smoke Subaru Outback 2010-2014 | 194484

Vehicle Fitment

2010–2014 Subaru Outback

Nothing beats cracking your windows on a humid or rainy day—but doing so often invites moisture, wind, insects, dust, and debris into your cabin. AVS® In-Channel Ventvisor® Window Deflectors solve that problem by allowing fresh air to circulate while keeping the elements outside where they belong.

Designed to install discreetly inside the window channel, these vent visors offer a sleek, streamlined appearance that looks factory-installed while delivering dependable weather protection. Whether you’re driving through a rainstorm, parked on a hot day, or cruising a dusty road, AVS® Ventvisors help keep your interior clean, dry, and comfortable.

Constructed from durable, impact-resistant acrylic, these deflectors resist cracking, chipping, scratching, and fading. The UV-resistant dark smoke finish maintains its appearance over time while reducing glare and interior heat. With AVS® quality and RealTruck backing, these vent visors are built for long-term performance and daily use.

Features

• Impact-resistant acrylic construction

• UV- and scratch-resistant for long-lasting durability

• Dark smoke finish for a clean, OEM-style look

• In-channel design for a sleek, low-profile appearance

• Allows fresh air in while keeping rain, wind, and dust out

• Helps reduce interior wind noise, fogging, and heat buildup

• Shields eyes from sun glare for safer driving

• Car-wash safe

• Limited lifetime warranty

• Proudly assembled in Georgia

Installation

AVS® In-Channel Ventvisor® Window Deflectors install easily using automotive-grade 3M™ double-sided adhesive. No cutting, trimming, or drilling is required.

Installation steps:

1. Clean and prep the upper window channels thoroughly

2. Peel the adhesive backing

3. Align and press the deflectors firmly into the window channel

4. Roll the windows up to apply pressure and ensure proper adhesion

Important Window Calibration Note

This vehicle is equipped with a “bounce-back” safety feature, which may cause the windows to stop or roll back down after installation. This is normal with in-channel vent visors.

To recalibrate:

1. Pull the window switch fully upward until the glass stops

2. Continue holding the switch for 2 seconds

3. Leave the windows fully closed for 72 hours

4. Press the down switch and allow the window to fully open

Once completed, the one-touch up/down function should operate normally.

If bounce-back persists, ensure the visors are properly seated in the channel.
For vehicles with one-touch windows that prefer a simpler install, tape-on vent visors are also available.