GiroDisc Slotted Front Rotors 324mm Nissan Skyline GT-R R32/R33/R34 1989-2002 | A1-357

These GiroDisc 2-piece rotors are a direct replacement for the front axle on Nissan R32 (V-Spec), R33, and R34 Skyline GT-R models. The fully floating assembly sheds unsprung weight and rotating mass from the front of the car.

The rotor rings are machined from a proprietary high-carbon iron casting formulated to GiroDisc's own specification. The 48 curved vanes pull air through the hub to cool the rotors under hard use. The 2-piece design means the aluminum hat is reusable - when the ring wears down, you replace just the ring (part D1-357) instead of the full assembly.

All major components - hats, rotor rings, and drive pins - are manufactured in-house at GiroDisc's facility in Bellingham, WA, from domestically sourced materials. The hat is 6061-T6 aluminum with a black anodized finish. Drive pins are a high-strength steel alloy, cadmium-plated for corrosion resistantce. Rotors are assembled with spring clips and Belleville washers for race-ready float, without the noise of loose hardware on the street.

Fitment: Nissan Skyline GT-R - R32 (V-Spec), R33 (all), R34 (all). Front position, 324mm.
Note: This is the 324mm front rotor used across R32 V-Spec, R33, and R34 GT-R models.

Key features and benefits

• 2-piece design reduces unsprung weight and rotating mass at the front axle
• 48-vane curved rotor design pulls air through the hub for cooling under hard use
• Replaceable ring design - swap just the ring, not the full assembly, when worn
• 6061-T6 aluminum hat with black anodized finish
• Cadmium-plated steel alloy drive pins for corrosion resistantce
• Spring clip and Belleville washer hardware for race-ready float with no street noise
• Hats, rings, and drive pins manufactured in-house in Bellingham, WA from domestic materials