PRL Intercooler Core Upgrade Honda Accord 2.0T & 1.5T 2018-2020

Rated 5.0 out of 5
Based on 1 review
PRL-HA10-IC
6 In stock
Intercooler Cores

🚀 If you were a VIP member, you'd be getting $30.00 in BuildBUX for buying this part 🤷 Join us!

$599.99


Fastrak Delivery: , Order within hours minutes




Finish :
$599.99

It’s no secret that Honda’s newer turbo platforms are extremely susceptible to heat-soak, especially when retaining the factory intercooler. Excessive heat-soak increases the risk of detonation and causes major power-loss due to high charge air and cylinder temperatures. These issues become even more prevalent with spirited driving and/or increased power outputs.

The PRL Motorsports intercooler upgrade decreases charge air temperatures while increasing potential airflow with its dense 27 x 3.5 x 7.25" 550+ horsepower rated bar-and-plate core. Our intercooler core which increases surface area by 85% and internal flow by 83% to allow optimal cooling and airflow.

This intercooler utilizes factory mounting spots with cast aluminum end tanks as well as all factory air ducts/shrouds. *To maintain consistency with most of our PRL product line, no cutting, fitting or trimming is required. Kits will come with all hardware needed for a seamless install.

Kit Includes:
  • (1) Intercooler Assembly
  • (1) Cardboard Stencil w/ “PRL” Logo
  • (1) Buna O-Ring
  • (1) 304 Stainless Worm Clamp

Performance Gains:

  • Mid-range & top-end power gains
  • Major drop in post charge air temperature at peak
  • Increased efficiency & consistency in power delivery
  • Increased engine safety

Intercooler to Charge Pipe Bolt(s) Torque Spec:

  • 18 ft/lb
If you plan to utilize the provided stencil to represent PRL on your intercooler:
-Clean and make sure your intercooler is dry.
-Place the cardboard stencil onto the front of the intercooler (Make sure the intercooler is not upside down, the PRL logo is on the driver's side end tank).
-It is recommended to tape down the stencil to have a sharp logo and to avoid moving.
-Mask off or cover the end tanks to avoid overspray.
-Apply a high temp engine enamel style spray paint (we recommend Duplicolor DE1635 Ford SemiGloss Black, any color can be used).
-Multiple coats may be needed to have full coverage, this varies per color.
-Allow to dry 30-60 minutes before installing the intercooler.
-If any mistakes are made such as runs/overspray acetone or paint thinner can be used to remove any unwanted paint or to remove the stencil entirely, though this will take some time.
-Keep the stencil handy and in a safe spot without bending if you would like to refresh your intercooler after years of road debris blasting it! (Stop blowing holes in my ship!)
average rating 5.0 out of 5
Based on 1 review
  • 5 Stars
    1 Review
  • 4 Stars
    0 Reviews
  • 3 Stars
    0 Reviews
  • 2 Stars
    0 Reviews
  • 1 Star
    0 Reviews
100% of reviewers would recommend this product to a friend
1 Review
Reviewed by Jorge M., from United States
I recommend this product
Rated 5 out of 5
Review posted

Works great!!

I did not have a single issue with the prl intercooler and it def does it’s job ❤️

Loading...
Was this helpful?
PRL Intercooler Core Upgrade Honda Accord 2.0T & 1.5T 2018-2020
You have successfully subscribed!
This email has been registered
x